2F39 2110 London Euston to St Albans Abbey (with announcements)
30th December 2022Drive the only direct service of the day from London Euston to St Albans Abbey as far as Watford Junction. As per timings on 15/09/2022.
Weather: Light rain
Duration: 25 minutes
Requirements:
DTG WCML South
DTG Portsmouth Direct Line
AP Class 350 EP
AP Class 319 Vol. 1 (Static AI only)
To install imply extract the downloaded file and drag and drop in your RailWorks folder
Please note: The announcements used in the scenario are not to be used anywhere else without my permission
when coming into watford it sends me straight on into platform 8 not into 11 not sure why
That’s really weird. No idea why that should be happening.
Very nice, I too liked the announcements. Thank you.
Really enjoyed this scenario I liked the cautionary signals towards the end of the scenario plus the audio announcements was a good touch well done mate for nice small run to st Albans abbey
The path is not set for my train, I am just set towards buffer stops after departing Euston.
Really strange. No idea what’s causing that to happen. Apologies.
Please can you help I have downloaded your scenario do I paste both files into my railworks folder
__MACOSX
content
Hi. Apologies, just paste the Content folder into your RailWorks.
Good Evening,
Could you please direct me where to find the reskins for the Hamburg FTA and Hapag FSA wagons please
Apologies, I have resolved the issue, just need to re unpack the .ap file
Tried the Scenario, 2T62 and 2F39 conflicting, unable to find destinations
Hiya. Just ran the scenario again and can’t find an issue with it my end. What is the error showing in the scenario editor?
it starts off showing unknown issue, then found the 2T62 cant find path and to its own destinations. This then causes player train not to find destinations. therefore not having any path for the length of the scenario. Im sorry about this but any help will be greatly apricated
In the folder I had 2 files
__MACOSX
Content
I Tried both and got the same issues.
After reloading the scenario. I got this message.
Scenario Failed to load:
Driver ‘2F39’ at Lat 51.52821 Long -0.13443 – Route is Blocked – 2T62
Driver ‘2T62’ at Lat 51.65184 Long -0.38397 – Many Failures – See logmate
Then in Scenario Editor I get the Following in full and in order:
Drivers Failed
2F39 and 2T62
2F39 at Watford Junction Platform 11 in timetable. Error Message below;
2F39 unable to Pass blockage
Route Blocked by 2T62
Route Blocked by 2T62
Route blocked by 2T62
2T62 Timetable at Harrow & Wealdstone Platform 6. Error Message below;
2T62 Unknown Error
due to this the timetables for both trains were in red, I have pictures, unable to post them on here
out of curiosity, I then pressed play put of Scenario Editor and got the following;
Scenario Failed to Load
Driver ‘2F39’ at Lat 51.52821 Long -0.13443 – Route is Blocked – 2T62
Driver ‘2T62’ at Lat 51.65184 Long -0.38397 – Cant Find Destination – Harrow & Wealdstone Platform 6
Hi. Sorry for the late reply. Should just be the Content folder you need to copy. All I can suggest is flying to 2T62 in the scenario editor and deleting it as that seems to be causing the issue.
Hi Toby, thank you for still getting back to me, I will try it again but it didn’t solve it the first time
Nice one – many thanks!
Glad you enjoyed it.