2H98 07:54 Helensburgh Central to High Street
27th December 2023Hello! This is one scenario for DTG’s Suburban Glasgow Northwest to Airdrie route…
DESCRIPTION:
An oddball of the midweek Scotrail EMU diagrams is GW044, a Class 320 turn that today has been substituted with a Class 318 due to a failure on Yoker C.S. this morning. Since arriving with 2H35 from Dalmuir, you will now assume control of 2H98, the 07:54 all stops service from Helensburgh Central through to High Street (Glasgow) before running ECS to Airdrie where the unit will stable until the afternoon peak. Year: 2008
TRACK COVERED:
Helensburgh Central to Airdrie C.S.
TRACTION:
SPT (First Scotrail) 318263
DURATION:
85 Minutes
DIFFICULTY:
Medium
CONDITIONS:
Spring, High Cloud
REQUIREMENTS:
PAYWARE:
STEAM:
• GEML: London to Ipswich
• Suburban Glasgow Northwest to Airdrie
ARMSTRONG POWERHOUSE:
• Class 156 Diesel Multiple Unit Pack
• Class 318 Electric Multiple Unit Pack
• Class 320/321/322 Electric Multiple Unit Pack
• Cloud Enhancement Pack (Optional)
• Signal Enhancement Pack
• Sky & Weather Enhancement Pack (Optional)
FREEWARE:
SUBURBAN GLASGOW:
• Class 334 Reskin Pack
VULCAN PRODUCTIONS:
• Class 320 Scotrail Carmine and Cream
UPDATE LOG:
Nothing yet! (27/12/2023)
…and that’s it for this scenario. My other creations can be found here.
Anyway, enjoy! 🙂
I can’t get this bugger to start from cold, I’m following everything as per AP’s manual but the pressure needle just won’t move!! HALLLLPPPPP!!!
Perhaps a bug within your install? Make sure the Pan has been raised correctly and the Aux switches are turned on behind the DVRs panel
Re-installed the AP pack and the scenario, still nothing…
Check out my message below, you need to start from the other cab 😉
I reach out to AP and the pack has been corrected on this day, along with the two volumes of class 317!
really really good scenario. I enjoyed it. Thanks dude.
Thanks again Geeky!
An excellent scenario thank you
Thanks John, glad you enjoyed
Excellent scenario thank you very much
Thanks Ross!
A very nice run, thanks for sharing!
FYI, the unit can only be cold started from the trailing DTSO, I think you didn’t apply the ;Cold=1 option to the right end, it must be applied on the same DTSO that bears the player icon as per AP’s manual.
Also you didn’t provide a ;CSR=, so the SMA doesn’t register with the right headcode (thought it would be impossible to switch to the ECS one en-route so maybe you did that on purpose 😉
And while we’re at it, I think ;RW=1 would be appropriate too!
i got it to start from cold, but by pure luck I pressed pan down instead off pan up what tripped the VCB what then allowed the train to build air when i pressed pan up