[9F32] 05:37 Milton Keynes Central to Liverpool Lime Street
22nd August 2019[9F32] 05:37 Milton Keynes Central to Liverpool Lime Street
In this scenario you will drive a Class 350 on the early morning service from Milton Keynes to Liverpool Lime Street.
You will start by picking up your empty train from Bletchley and taking it to Milton Keynes to begin the service.
Part 1. Milton Keynes to Birmingham New Street
Part 2. Stafford to Liverpool Lime Street
This scenario uses the 2019 timetable.
There are two versions of this scenario, one uses the DTG Class 390 and the other the old S9BL version.
Scenario routes: WCML South V5.2 (APTEP)
WCML Midlands & North West “The Missing Link”
Scenario length (Total) 170 mins
Requirements:
Steam
Class 390 (DTG or S9BL)
Liverpool-Manchester Route
London Waterloo to Portsmouth
North Wales Coastal
West Coast Main Line Over Shap Route
EWS Class 66 v2.0
Powerhaul Class 66 V2.0 Loco
EWS Class 92 Loco
Class 159 DMU
BR Class 150/1 DMU
Class 156 Loco Add-On
Class 86 Loco
AP
Class 350 Enhancement Pack
Class 319 Electric Multiple Unit Pack Vol. 1
Class 66 Enhancement Pack
Class 158 (Perkins) Enhancement Pack
Class 150/1 Enhancement Pack
Class 321 Electric Multiple Unit Pack
Class 92 Sound Pack
Mk3 Coach Sound Pack
AP Sky/weather Enhancement
Just Trains
Class 67 Advanced & Car Carriers
Cargowaggon IWB PlusPak
Cargowaggon Flat IGA PlusPak
ATS
WCML Midlands & North West “The Missing Link”
WCML South V5.2 (APTEP)
Transport for Wales Class 158
Caledonian Sleeper Mk3A Sleeper Pack
Class 350 Cab and Pass View Patch
Freeware
Superalbs Class 156: Arriva Rail North
DPSimulation
Class 158 ‘East Midlands Trains’
AP packs have their own individual requirements which are required for this scenario
I think this also needs the ATS “Class 350 Cab and Pass View Patch” – an initial RWTools check noted that the “LNWR_AP” np stock (used for quite a few consists) was missing – quickly fixed by downloading and installing the patch. Have only tried a short test run of the scenario so far, but it looks very good (I use the default track, rather than the APTEP).
Chris.
You may be right, sometimes hard to keep track of all assets used.
Finished the WCML South S9BL scenario (don’t have the Missing Link yet, or the DTG 390), everything worked fine and I enjoyed the drive, so thanks for uploading this.
The “missing” 350 was no problem as I don’t have the AP 319, so had to use RWTools anyway to change these and only mentioned the patch in case someone else was in the same situation.
Incidentally, and nothing to do with the scenario, I had just reinstalled the AP 350 Enhancement pack and the Geo files were missing for the “LNWR_AP” stock (all the rest were OK), so initially I could only see couplings and pipes etc. – a quick fix again, but a bit strange.
Chris