1O11 0850 Manchester Piccadilly to Brighton (2003) v2
23rd July 2021Description: Good Afternoon Driver, Today you are going to be operating a Virgin CrossCountry service to Brighton from Reading where you have just taken over from the Manchester driver. You will be calling at: Kensington Olympia (12:41), East Croydon (13:15), Gatwick Airport (13:31), Haywards Heath (13:48), & Brighton (14:14). Apart from that you should have a lovely run up to Brighton this morning! Good Luck & Enjoy! 🙂
Briefing: Good Afternoon Driver, Today you are going to be operating a Virgin CrossCountry service to Brighton from Reading where you have just taken over from the Manchester driver. Good Luck & Enjoy! 🙂
Scenario Start Time: 12:32pm
Route: Danny’s Noth London, Goblin and South London to Brighton 2015 – 16 route
Track Covered: Reading to Brighton via Clapham Junction & Kensington Olypmia
Traction: Virgin CrossCountry Class 220012
Date: 23rd July 2003
Duaration: 1 Hour & 45 Mins
Difficulty: Hard
Requirements:
Just Trains Class 220/221
AP Class 313
AP Class 375/377 EP
AP Class 455 Vol.1/2 EP
South West Trains Class 442 Reskin
AP Class 444/450 EP
Southern Slam Doors
AP Class 319 Vol.1/2 Mutiple Pack
DTG Class 166
Masterkey Simulations Class 460
Enjoy! 🙂
Update log:
This scenario updated to Version 2 to fix several issues players faced when playing this scenario. Hopefully all of these issues should be resolved now
This scenario updated to Version 2
sorry I meant not impressed you have let me down on this scenario
today I downloaded this scenario after this scenario had been fixed however I get a red signal at Willesden please fix this broken scenario. because I am very impressed.
I am sorry we are still looking into this issue. We are having trouble trying to resolve this issue. We thought we fixed the issue when releasing V2 but we unfortunately did not. ^Ciran
I have just downloaded a fresh copy of the route and installed V2 of this scenario, booted it up and ………………..it didn’t work! Just the same as the first time, blocked at first junction and couldn’t proceed. Have to put this one down to quirky TS working for one and not another. If anyone has got this to work let us know.
A new update has released for 1O11 0850 Manchester Piccadilly to Brighton (2003)
This is to fix several issues players were facing when playing this scenario.
To redress the following issues:
– Red signal at Willesden Junction
– Timings
– Pop Up Messages For Red Signals
– Train Now Goes Through The Quarry Lines
– Most AI Trains Go Through On The Quarry Lines
– Mileage
– ETA
– Rolling Start Active Now
– Manual Points Fixed
– AI Timings Fixed
Players can now experience this scenario with no issues.
This V2 update is available to download now and play
Enjoy! ^Ciran
Hello everyone, this scenario has been updated to version 2 to resolve all the issues players where facing when playing this scenario.
Hopefully all of these issues should be resolved now.
This scenario updated to Version 2.
Thank you! 🙂 ^Ciran
Hello everyone, I know there are several things wrong with this scenario starting off with the red signal at the start of the scenario. For the time being all signals you see as “Red” just tab them to gain access. I will also fix the timings as I know you arrive at East Croydon seven minutes early. So from today I am working on a “Version 2” where that will resolve all off the issues in this scenario. Thank you! 🙂 ^Ciran
Your best bet is probably to just rebuild the scenario from scratch…
Hate to say it but it can fix a lot of issues most of the time.
I will try fixing the issues first. But that’s my last resort. Thanks. ^Ciran
I’m sorry like others have reported there are multiple issues with the scenario. First issue it is impossible to make the timing of the first stop at Olympia because you get held at the red outside until AFTER you should have departed the station. None of the AI trains have destinations set. The routing of the AI trains is questionable especially the Gat EX units! Additionally there are so many signals that need tabbing and you are not told about any of these with popup messages that would have been useful. Can’t recommend this at all and stopped the drive at Gatwick because there are just too many things wrong to enjoy it. Lovely idea but need to have a lot more refinement before it was released… Ben
I am sorry, I did not know all of these issues and when I tested this scenario I did not experience all the issues everyone is getting. From today I am working on a Version 2 of this scenario to resolve all of these issues. Thank you! ^Ciran
Doesn’t work, blocked at first red signal, route not set.
It doesnt display mileage or ETA as a result it doesnt move past the first junction as it stick on a red signal
When I was testing the scenario I got the mileage and ETA and the stopping locations and everything. I have made sure this scenario runs fine. And when I did testing the scenario was perfectly fine. So I don’t know why you are experiencing issues. Am sorry ^Ciran
Yes, getting the exact same issue as Anthony, No milage, no ETA and stuck on a red signal.
I’m having the same issue too pal. No rolling start as 220 starts in emergency stop mode and red signal at the first junction.
Well, I don’t know how I can fix the issues all of you guys are experiencing. Because it’s all running fine for me. And testing went all fine. So on my end the scenario is playing as expected. But thanks for telling me all the issues you guys are experiencing. ^Ciran
You cannot just ignore the problems people are having with your scenario. If people are experiencing problems you really should try and fix it or at least investigate these problems. As it seems like it is quite an easy fix from what people are saying.
I have, I have tried to look into issues but I am not experiencing on my end so I can’t really resolve the issue. I don’t know why other people are having issues. Yeah it does sound like a easy fix but I don’t know what is causing the problem but thanks for your recommendation. ^Ciran
i have the c6 442 swt installed.geo files in place.still comes up with missing stock.
Just ignore it, you won’t see the South West Trains Class 442 anyway as it leaves Clapham Junction before you get there. ^Ciran