vtec/lner ic225 not installing

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #1910737
    callum wilkinson
    Participant

    Hey there,
    Ran the installer to the letter.
    I have both the dtg91 and the ap 91.
    installed into the default folder steam/railworks.
    and boot it up and no bueno, nothing there.
    renstalled and again nothing.
    Thanks in advance.
    Callum

    #1912066
    CarrotPie
    Participant

    Are you using the ATS installer or the.exe included? If you’re using the ATS installer, then make sure you’ve downloaded the manual install version.

    #1927793
    callum wilkinson
    Participant

    no its just the .exe

    #1928820
    CarrotPie
    Participant

    Have you ticked the correct boxes in the Editor?

    #1931118
    callum wilkinson
    Participant

    yea, i also ticked the move geo? files across
    I’ve seen lots of other people are having the same issue

    #1931332
    callum wilkinson
    Participant

    it says something about install a .bat file. i carnt find it. can only find a install-me file. of which I did

    #1931853
    callum wilkinson
    Participant

    so I think its all installed properly now but I still can’t see them, I don’t need a scenario I can just quick drive right?

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.