The East Coast Mainline Merge

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #257074
    #441745
    dunkrez
    Participant

    Hi, firstly, a big thank you for some awesome new additions to TS. Watching your YouTube channel led me from TSW to TS2019 and I’m now a satisfied train simmer. The thing that coaxed me into subscribing is the ECML merge 🙂

    However, even though I have all the dependent routes and their dependencies, the ECML merge won’t show in the quick drive route selection. I’ve been through the route properties xml file to make sure I have every requirement right down to the Just Trains modern signal pack (I was missing this).

    I’ve copied all assets and content over to the railworks folder (1.22GB, some 17,000 files), cleared the game cache, tried everything I can think of that might be affecting the ability for the game to recognise the route but it just doesn’t show up.

    Any help would be hugely appreciated, I can’t wait to drive London to Edinburgh!

    #443871
    dunkrez
    Participant

    I figured this out – you literally have to build a quick drive. This was a good exercise in getting to grips with the editor 🙂

    May need a RAM upgrade from 16GB to as much as I can fit in my motherboard to run the ECML without any glitches.

    #549826
    Cal
    Participant

    Any chance of sharing your QD scenario? I made one but it fails to load.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.