Alan Thomson Simulation › Forums › Alan Thomson Simulation Forums › Support Forums › Alan Thomson Simulation Products › ATS TPE Class 802 Reskin
- This topic has 5 replies, 4 voices, and was last updated 2 months ago by Brendan Jennings.
-
AuthorPosts
-
27th August 2021 at 18:58 #2468781FizzbinParticipant
For ChatMoss this reskin is listed as requirements for a scenario. Where I can get this, I found nothing elsewhere (here or on other sites)?.
The only thing I found was a link to a site that doesn´t exist anymore [https://simvue.co.uk/product/class-802-hull-trains/]
27th August 2021 at 19:10 #2468835MDegreeParticipantI’m Fairly Sure it’s included in the Chat Moss Route.
27th August 2021 at 23:29 #2469712Robbo13ParticipantOk so the website you linked (Simvue) closed down a while back now.
As mentioned above, a TPE 802 does come with the route. In you Railworks folder there should be a CM TPE 80X.bat file. Run that and then try the scenario again.
28th August 2021 at 18:06 #2471804FizzbinParticipantthanks. Good to know. But why it is listed as requierement, when it is included, and nothing th the manual too? Anyway- it works
28th August 2021 at 18:29 #2471850Robbo13ParticipantIt’s just so people know that it’s needed, that’s why its down as a requirement, makes it easier for people downloading to know what they need to run the scenario.
As far I’m aware it should have installed the 802 when installing the route, however for some reason, which the devs might know, it wasn’t included and had to be installed separately- hence why running the .bat file works.
At least it’s working now.
23rd April 2022 at 22:58 #3232662Brendan JenningsParticipantIgnore this, can’t delete it but I didn’t read the thread through!
-
AuthorPosts
- You must be logged in to reply to this topic.